Instruction manual

Connect Systems Inc. - Model 9800 Page 10
PROGRAMMING THE 9800
The 9800 has four easily-accessed programming areas: Operating
Parameters, CW ID, Speed-Dial Phone Numbers and Toll Override
Selections. To enter one of the programming areas, turn the power off,
press and hold the corresponding programming area button (No. 1 for
Operating Parameters, No. 2 for CW ID or No. 3 for Speed-Dial Phone
Numbers, No. 4 for Toll Override Selections) and simultaneously turn
on the power. The display will show 0.x., where x is the number of the
programming button that is being pressed. Release the button, and
programming may begin.
Each programming area has the following features in common:
1) Programming line numbers are displayed with the dots
illuminated on the displays. e.g. 0.1., 4.5. etc.
2) Data values are displayed without the dots illuminated.
e.g. 00, 30, etc.
3) Data is entered at a line number by pressing the desired
digits followed by the 'P' key. Consider the 'P' key as the
enter key.
4) The GOTO Any Address line is displayed as A.A. This line
is used to branch to any line number in the current
programming area. For example, the current line is A.A.
and you wish to goto line 30. Enter 3 0 P on the keypad
and the display will read 3.0.
5) Pressing only P at the A.A. line will advance the line
to 0.1. Pressing only P at any other line will advance to
the next available programming line.
Note: In CW ID, Speed-Dialer and Toll Override Selections the
next line will be the next numeric line number. In Operating
Parameters programming, the next line is often determined by
selections made at the current line and is not necessarily the
next numeric line (see the 'Programming the Operating Mode and
Parameters' section).
6) To view the data at a given line number, briefly press C
on the keypad and then release it. The display will then
show the data for a few seconds and then re-display the
current line number. Consider 'C' the data 'see' key.
7) At any point during programming, you may return to the
A.A. line by holding down the C key until A.A. appears on
the display (approximately three seconds).
MASTER RESET COMMAND
All user programmable selections in Programming Areas No. 1, 2, 3 and
4 can be simultaneously reinitialized to the factory default settings
by simultaneously pressing the 3 and 7 keys on the internal keyboard
while powering up the 9800 with the front panel power switch. TO
REITERATE, all user programming including Operating Parameters, CW ID,
Speed-dial phone numbers and Toll Override Selections will be lost if
a 3+7 reset is performed!