Specifications

Page 7
This mode allows the user to manually dial up to a 50 digit number before it is actually transmitted. Using this
mode, a telephone number can be accumulated in memory, and then transmitted at a later time. It is accomplished
by pressing the "0" key, followed by the telephone number desired. When you are ready to send the number, press
the PTT switch briefly to initiate the transmission.
This feature may also be used for applications where the ANI-UP code is needed to obtain a system connection, and
to dial a commonly used telephone number (Example):
"0 * 5551212"
Programs the "Store and Send" function with the (pre-programmed) ANI and the desired telephone number (555-
1212).
To use the feature: When ready to proceed with the call, momentarily depress the PTT switch. The microphone will
send the ANI-UP code automatically. Once the dial tone is heard, again press the PTT switch momentarily and the
telephone number will be sent. To cancel the dialing sequence, press and hold the PTT switch for three seconds and
release. A <beep> tone indicates that the "Store and Send" sequence has been cancelled by the user.
Timed Manual Dialing
The second manual dialing mode is called "Timed Manual Dialing", and allows the user to manually enter up to 12
keypad digits, similar to the Manual Dialing Mode described earlier in the Operation section. In using this mode,
the DTMF digits are sent at a fixed length. To enable the Timed Manual Dialing mode, press the "0" key and within
2 seconds, dial the DTMF digits that are to be directly manually dialed. The transmitter will unkey 2 seconds after
the last digit is pressed.
Note: In order for the Timed or "Store and Send" DTMF dialing to be functional, the microphone must first be
placed in the DTMF autodial mode by the dealer.