User Manual
11
OPERATION INSTRUCTIONS
GENERAL CUTTING
1. Unplug the reciprocating saw from the power supply.
2. Make sure that the workpiece is firmly anchored. Clamp the workpiece to prevent it from
slipping or moving while cutting.
3. Use the appropriate type and size of blade for the workpiece material and size.
4. Adjust the pivoting shoe as necessary to make sure that the blade will extend beyond
the shoe and the workpiece at all times.
5. Adjust the pivoting shoe as necessary to expose unused blade teeth for longer blade life.
6. Check for clearance beyond the workpiece so the blade will not impact another surface.
7. Mark the line of cut clearly. If cutting metal, apply cutting oil on the line.
8. Plug in the saw.
9. Hold the saw firmly with both hands. Make sure to keep your hands on the insulated
gripping areas only.
10. Depress the trigger switch to start the saw and bring it to maximum desired cutting
speed before applying the blade to the workpiece.
11. Do not force the tool. Place the pivoting shoe firmly on the workpiece while cutting. Use
only enough steady pressure on the blade to keep the saw cutting. Reduce pressure as
the blade comes to the end of the cut.
12. Cutting speeds should vary with the workpiece. Hard materials, such as metals, require
lower speeds; use higher speeds for softer materials.
13. Allow the saw to come to a complete stop before removing the blade from the workpiece.
14. If sawing fibreglass, plaster, wallboard, or spackling compound, clean the saw motor
vents frequently with a vacuum or compressed air. These materials are highly abrasive
and may accelerate the wear on motor bearings and brushes.
WARNING!
• Before plugging in the tool, always check to see that the switch is actuated properly and returns
to the off position when released.
• Hold the tool only by the plastic handle and the insulated grip area, which will help prevent
electric shock. When sawing into walls or floors, you may encounter electrical wiring. Sawing into
a “live” wire will cause electric shock.
• Do not allow familiarity with the saw to make your careless. One careless fraction of a second is
enough to inflict serious injury.