Service manual

96022 Revision L 4-11
StorageTek Protected
Fibre Channel Router Card
Note: If the fibre channel router card is not being replaced, a vacancy plate must be installed in its
place to prevent electromagnetic interference.
5. If necessary, install a vacancy plate on the opening for the fibre channel router card using three
screws found in the vacancy plate spares kit, PN 309871304.
1. Vacancy plate
2. Screws
6. Slide the router into the slot.
7. On the new router, remove the protective cover from the GBIC connector below the port.
1. Cover
8. Attach the router to the frame with the three screws.
9. Attach the fiber cable to the GBIC connector.
10. Attach the SCSI cables to the connectors.
11. Go to “Restoring Operation” on page 4-79.