Service manual

Drive SCSI Cable Assembly

4-8 Revision L 96022

StorageTek Protected

4. Use a 3/16 inch driver to remove the four jack screws from the SCSI connector.

1. Screw (4)

5. Remove the conductive foam shield from the cable and place it on the new cable.

6. Reverse the steps to replace the FRU.

Note: The wide part of the cable is on the left side as you face the cable.

CAUTION:

Possible equipment damage: Make sure the SCSI cable does not block the fan before

you close the drive door.

Possible cable damage: Make sure you move the SCSI cable out of the way before

you close the drive door.

7. Go to “Restoring Operation” on page 4-79.

L201_244