Service manual

Drive Fan Assembly

4-4 Revision L 96022

StorageTek Protected

3. Remove the two plastic rivets from the finger guard. To do this, use a flat-blade screwdriver to

remove the center pin from the plastic rivet, then remove the rivet.

Note: When you replace the rivet, place the rivet into the finger guard, then place the center pin into

the rivet.

4. Retain the rivets and finger guard for the new fan.

1. Center pin

5. Turn the drive door latch to your left to open the drive door.

6. Disconnect the drive fan power connector at the bulkhead.

7. Cut the cable tie wrap, making sure you do not damage the fan power cables.

1. Connector

2. Tie wrap

L201_309

L201_240