Service manual

96022 Revision L 3-3
StorageTek Protected
PC to LLC Card Procedure
The CSE> prompt appears.
6. Type download and press <
Enter>.
A message appears stating that you have two minutes to begin sending the new
firmware version.
7. Locate the
TRANSFER button at the top of the window, and point to SEND FILE.
A box appears, allowing you to browse to the file location of the files you unzipped in
“Web to PC Procedure.”
8. Double-click on
release.prm.
The SEND FILE box appears, showing the pathname and the protocol chosen.
Protocol should be set to Z-MODEM.
9. Click on
SEND.
The status window for the transfer appears.
CAUTION:
Equipment Damage: Do not attempt to perform any operations on the PC
or library until the operator panel displays DOWNLOAD COMPLETE. You will
damage the LLC card if you do not wait for the process to complete.
10. Wait for the following message: Download successful. Reboot is
needed for new code to take effect. Would you like to
reboot now (yes/no)?
11. Respond with ‘yes’ to reboot the machine and activate the firmware. Or, you
may press the inline power switches to the O position, then to the —position.
Note: If you do not reboot or press the power switches, the old firmware version
will remain active. When the next reboot or power cycle occurs, the new
firmware will become active.
12. Verify that the version is correctly listed on the operator panel when the reboot is
completed:
a. Press the Menu button on the operator panel.
b. Arrow down to the LIB/CONFIG menu.
c. Press SELECT.