Service manual

Using Library Status Tool
2-20 Revision L 96022
StorageTek Protected
c. In the Policy Entry window type: http://<library IP>/
libconnect.jar in the CodeBase field, where library IP is the 12-digit
library IP address (for example, 129.80.58.95).
5. Click Add Permission.
6. From the Permissions pull down menu, select FilePermission.
7. Specify one of the following in the Target Name field:
• To load code from the Library Status Tool, type the full path and the name of the
firmware file you downloaded to the hard drive (for example, C:/code/
firmware.prm).
• To save a report to your hard drive from the Library Status Tool, type the full
path and the name of the file you wish to save the report page to (for example,
C:/report/report.txt).
Note: Independent of the operating system, use a forward slash when specifying
the path for the filename.
Also, write down this path and filename; you have to enter this same path
and filename when saving the report or loading code in the Library Status
Tool.
8. From the Actions pull down, do one of the following:
a. Click Read for code download.
b. Click Write or write, read, write, delete, execute to save
the report to a file.
c. Click OK.
9. Click Done.
10. Select File > Save to save the policy.
If an error was displayed when you launched the policytool:
a. From the File menu select Save As.
b. Type the name of the policy and the full path as noted in Step 4a.
11. Select File > Exit to close the Java policytool.
To start the Library Status Tool:
1. Open Internet Explorer (5.0 or later) or Netscape (4.5 or later).
2. Enter the IP address in the Address Bar.
The Element ID section lists the volume number and media type for each cartridge.
The Drive section lists such items as the SCSI ID, model, vendor, serial number, firmware
version, and state (such as loaded or unloaded).