Service manual

96022 Revision L 2-9
StorageTek Protected
Monitoring the Operator Panel for Messages
configuration menu, the status display shows Needing Lib Reset: SELECT to
Reset the Library. Press the
SELECT button to reset the library.
■ Monitoring the Operator Panel for Messages
You can monitor the operator panel display for messages at any time during library
operation. In particular, the status display shows messages for:
•Library
•Drives
• Personality module
• Hardware Monitor
•CAP
• CAP magazine
Viewing the Status of the Library
To view the status information for the library, look at the first line in the status display.
Table 2-5. Library Status Messages
Status Message Explanation
Lib Init Required The library requires initialization. This message might
appear momentarily after you close the front door of the
library. If the message remains on the screen, open and
close the front door. The library then begins its
initialization cycle.
Library Not Ready The library is not available to perform tape management
actions. Some status information might be available
through the network interface.
STK L80-Ready The library has completed initialization and is ready to
perform tape management actions.
STK L80-Maint Mode The library is not ready because it is performing
diagnostic tests.
Library Requires
User Intervention
The robot failed.