Service manual

96022 Revision L 2-7
StorageTek Protected
Configuration
Configuring the Network
To use Library Status, you must configure the network. Access the Network Info/
Cfg Menu and complete the required fields as shown in the following table.
Note: Ask your system administrator for the IP address, the network gateway, and the
subnet mask.
See “Using Library Status Tool” on page 2-18.
Table 2-3. Network Information/Configuration Menu (Network Info/Cfg Menu)
Data Field Valid Values Explanation
Library
Name:
name Enter the name for the library in your network, where
name is up to 11 alphanumeric characters. This name
has no effect on library operation. This name is also
called the Domain Name.
IP
Address:
nnn.nnn.nnn.nnn Enter the address for network monitoring, where n is
0–9.
Note: You cannot assign an address such as
255.255.255.255.
Network
Gateway:
nnn.nnn.nnn.nnn Enter the gateway connection between subnets, where
n is 0–9. This is required only when such a connection
exists and is necessary to library operation.
Subnet
Mask:
nnn.nnn.nnn.nnn Enter this data to make the library accessible through
a subnet on a larger network, where n is 0–9. This field
is required only when applicable.
Web
Password
The default is horizon. To change the password,
press the
SELECT button, and use the arrows to
change each letter.
Ethernet
Address:
nn.nn nn.nn.nn.nn.nn The Ethernet address is set automatically.
Note: If you change any of the network configuration values, and you press the MENU button to exit
the configuration menu, the status display shows Needing Lib Reset: SELECT to
Reset the Library. Press the
SELECT button to reset the library.