Service manual

Configuration
2-6 Revision L 96022
StorageTek Protected
Configuring the Drives
Access the Drive Info/Cfg Menu and complete the fields for all drives installed in
your library. For more information about this menu, see
“Viewing the Status of the Drives” on page 2-10.
Table 2-2. Drive Information/Configuration Menu (Drive Info/Cfg Menu)
Data Field Valid Values Explanation
SCSI Id: 00–15 Enter the SCSI ID you have chosen for this drive, for example, 00.
This ID must be different from the IDs of other drives on the SCSI
bus. Valid IDs can vary, depending on the type of drive. Refer to
your drive documentation for more information.
Note: If you change the SCSI IDs and a Fibre Channel router is
installed, you must reinitialize the router by either a soft
reboot through the CSE interface or by pressing the power
switch to the O position, then to the — position.
On Bus
Status:
On
Off
On indicates that the drive is on the same SCSI bus as the library.
Off indicates that the drive is connected to a different SCSI bus.
Status Loaded This is the status of the drive. See Table 2-6 on page 2-10 for a list of
the statuses.
Type DLT 7000
DLT 8000
BNHMK DLT1
SDLT 220
SDLT 320
SDLT 600
SGT LTO
HP LTO
IBM LTO
The type of drive is set automatically during initialization.
Note: Type SGT LTO for the Quantum Certance drive.
Vendor The drive vendor is set automatically during initialization.
Code Ver: 20 The code version of your drive is set automatically during
initialization.