Service manual

Drive Tray Assembly

4-58 Revision L 96022

StorageTek Protected

CAUTION:

Possible component damage: Do not use a screwdriver to tighten the drive tray latch

knob.

10. Turn the knob all the way to the right to engage the latch and clamp it firmly into the frame.

11. Pull back on the tray to make sure the tray is securely latched. It should not move.

12. Connect the drive SCSI connector, P903, to the drive.

13. Connect the drive power cable, P904A/B, to the library.

14. Connect the serial interface connector, P6A/B, to the library.

1. P903

2. P904A/B

3. P6A/B

CAUTION:

Possible equipment damage: Make sure the SCSI cable does not block the fan before

you close the drive door.

Possible cable damage: Make sure you move the SCSI cable out of the way before

you close the drive door.

Possible component damage: Do not use a screwdriver to tighten the drive door

latch knob.

15. Close the drive door and secure it by turning the drive door latch knob to your right.

16. If you need to set a new SCSI ID, see “Configuring the Drives” on page 2-6.

Note: If you are using the same SCSI ID for the new drive as for the old one, the library will

automatically assign that same address to the new drive and begin functioning as before. If the

operator wants to assign a new address, have the operator follow the drive configuration

procedures in the L80 Tape Library User’s Guide, PN 96021.

17. Go to “Restoring Operation” on page 4-79.

L201_210