Service manual

96022 Revision L 4-57
StorageTek Protected
Drive Tray Assembly
CAUTION:
Load/unload problems: The latch must be fully loosened (disengaged) before you
slide the tray into the slot. If the latch arm contacts part of the library frame as it is
being tightened, it cannot be rotated to its fully locked position, and the tray will not
be firmly locked into the drive slot. This can cause alignment problems and the
camera can have problems reading the target.
8. Holding the replacement drive tray assembly as shown in the figure below, turn the drive tray latch
knob all the way to your right so that it is in its fully unlocked position.
9. Slide the replacement drive tray assembly into the empty slot.
1. Knob
2. Range
3. Latch arm (shown disengaged)