Service manual

96022 Revision L 4-55

StorageTek Protected

Drive Tray Assembly

1. Review the information under “Preparation” on page 4-1.

CAUTION:

Possible component damage: Do not use a screwdriver for the drive door latch knob

or drive tray latch knob.

2. At the rear of the library, turn the drive door latch knob to your left to open the drive door.

1. Knob

Note: The following figure shows a typical cable configuration. Your cables might differ slightly,

depending on your drive type.

3. Disconnect the drive SCSI connector, P903, from the drive.

4. Disconnect the drive power cable, P904A/B, from the library.

5. Disconnect the serial interface connector, P6A/B, from the library.

1. P903

2. P904A/B

3. P6A/B

L201_239

L201_210