Specifications

Merus Vanity Sconce
Installation Instructions
CERNOGROUP.COM T_949.715.1534 1751 MCGAW AVE, IRVINE, CA 92614 COPYRIGHT 2019 CERNO LLC. ISSUE DATE 10/25/2019
General Product Information
This product is suitable for damp locations.
This product is to be installed to a standard 4” junction box
with 3” round plaster ring or an octagon junction box.
CAUTION - RISK OF FIRE
This product requires installation by a qualied
electrician. Before installing be sure to read
all instructions and TURN POWER OFF TO THE
JUNCTION BOX
,QFOXGHG&ODVV/('
'ULYHU
&RQQHFWWR/LQH
9ROWDJH6RXUFH
$&,QSXW/HDGV
'&2XWSXW/HDGV
*UH\ 3XUSOH
9
'LPPLQJ
/HDGV
&RPSDWLEOH
9'LPPHU
RSWLRQDO
&RQQHFWWR)L[WXUH
,QSXW/HDGV
'LPPLQJ1RWHV
,QSXW9ROWDJH 'LPPLQJ0RGHV
9$& 7ULDF(/9RU9
9$& 9RQO\
9$& 9RQO\
Pull the line voltage wires from the junction box. Use wire
nuts to make connections between line voltage wires and
the driver. Connect a ground wire to the green ground screw
located on the mounting plate.
(Optional) If 0-10V dimming control is to be used, connect
purple and grey LED Driver leads to leads from remote 0-10V
dimmer.
Place the driver and the electrical connections inside the
junction box. Pull out the driver output wires and feed them
through the center hole of the mounting plate. Screw the
mounting plate onto the junction box using the provided
8-32 machine screws.
Mounting Plate and Electrical Connections
1
2
3
CRITICAL NOTE:
If 0-10V dimming is not being used, the tinned ends of
the purple and grey LED Driver leads should be snipped
o and these leads should be capped individually such
that they remain isolated from one another.
(Optional)
0-10V Dimming
Black
(Hot)
White
(Neutral)
Driver
output wires
8-32 screws
Mounting
Plate
Driver
ground
connection
2
3
1
Center of Fixtures
3”
10.625”
15.125”
19.625”
3”
3”
22
31
40