Installation & Assembly

Astrum
Installation Instructions
CERNOGROUP.COM T_949.715.1534 22892 Glenwood Drive, Aliso Viejo, CA COPYRIGHT 2020 CERNO LLC. ISSUE DATE 1/14/2020
E26 Base Version:
Use wire nuts to make electrical connections between xture leads and line service. Connect a ground wire to the ground screw on
the crossbar assembly.
Integrated LED Version:
Pull the line voltage wires from the junction box. Use wire nuts to make connections between line voltage wires and the driver. Place
the driver and the electrical connections inside the junction box and pull out the driver output wires and connect them to the xture
input leads. Connect a ground wire to the ground screw on the crossbar assembly.
(Optional) If 0-10V dimming control is to be used, connect purple and grey LED Driver leads to leads from remote 0-10V dimmer.
Use the provided 8-32 screws to secure the crossbar assembly to the junction box.
Making Electrical Connection
4
3A
Push the canopy upwards until the canopy is ush with
the ceiling. Use the canopy nut to secure the canopy.
E26 Base Version:
Insert the bulbs into the xture
Final Steps
5
6
4
BLACK
(HOT)
WHITE
(NEUTRAL)
8-32 screws
Ground
3B
3A
3B
8-32 screws
BLACK
(HOT)
WHITE
(NEUTRAL)
Optional:
0-10V Dimming,
Gray and Purple
wires
Driver output
to xture input
leads
4
Ground
,QFOXGHG&ODVV/('
'ULYHU
&RQQHFWWR/LQH
9ROWDJH6RXUFH
$&,QSXW/HDGV
'&2XWSXW/HDGV
*UH\ 3XUSOH
9
'LPPLQJ
/HDGV
&RPSDWLEOH
9'LPPHU
RSWLRQDO
&RQQHFWWR)L[WXUH
,QSXW/HDGV
'LPPLQJ1RWHV
,QSXW9ROWDJH 'LPPLQJ0RGHV
9$& 7ULDF(/9RU9
9$& 9RQO\
9$& 9RQO\
CRITICAL NOTE:
If 0-10V dimming is not being used, the tinned ends of the
purple and grey LED Driver leads should be snipped o and
these leads should be capped individually such that they remain
isolated from one another.
5