User`s manual

4.6 WDS Status

The Peers MAC Address, antenna 0/1 received signal strength, phy mode and channel

bandwidth for each WDS are available.

 MAC Address : Display MAC address of WDS peer.

 RSSI : Indicate the RSSI of the respective WDS's link.

 TX/RX Rate : Indicate the TX/RX Rate of the respective WDS's link

 TX/RX SEQ : Indicate the TX/RX sequence of the respective WDS's link

5. Client Bridge + Repeater AP Mode Configuration

When Client Bridge + Repeater AP Mode is chosen, the system can be configured as an Client

Bridge + Repeater APMode. This section provides detailed explanation for users to configure in the

Client Bridge + Repeater AP Mode with help of illustrations. In the Client Bridge + Repeater AP

Mode, functions listed in the table below are also available from the Web-based GUI interface.

5.1 Chose Your Operating Mode(Client Bridge + Repeater

AP)

The system administrator can set the desired mode via this page, and then configure the

system according to their deployment needs, Please click on System -> Operating Mode and

follow the below setting.