Safety data sheet

MSDS-No.: 162788

V002.2

Ceresit Wand spezial Reparaturmörtel

Page 5 of 10

Biological Exposure Indices:

None

8.2. Exposure controls:

Respiratory protection:

In case of dust formation, we recommend wearing of appropriate respiratory protection equipment with particle filter P.

This recommendation should be matched to local conditions.

Hand protection:

In the case of longer contact protective gloves made from nitrile rubber are recommended according to EN 374.

Perforation time > 480 minutes

material thickness > 0.1 mm

In the case of longer and repeated contact please note that in practice the penetration times may be considerably shorter than

those determined according to EN 374. The protective gloves must always be checked for their suitability for use at the specific

workplace (e.g. mechanical and thermal stress, product compatibility, antistatic effects, etc.). The gloves must be replaced

immediately at the first signs of wear and tear. The information provided by the manufacturers and given in the relevant trade

association regulations for industrial safety must always be observed. We recommend that a hand care plan is drawn up in

cooperation with a glove manufacturer and the trade association in accordance with the local operating conditions.

Eye protection:

Goggles which can be tightly sealed.

Skin protection:

Dustproof working clothes.

SECTION 9: Physical and chemical properties

9.1. Information on basic physical and chemical properties

Appearance

powder

grey

Odor

odorless

Odour threshold