Owner's Manual

LED Series
IXL Remote Annunciators
ENGINEER AND ARCHITECT SPECIFICATIONS
Models LED-1 and LED-2
l 8 Separate Points or Zones for Annunci-
ating either Trouble or Alarm Conditions
l Contemporary LED Annunciator
l Surface or Semi-flush Installation
l Operates on the IXL Network Communi-
cation Line
l Field Programmable
l Listed, ULC Listed, FM, CSFM and
NYMEA Approved
cation Line. This annunciator shall be addressable and
shall not require DIP switches or jumper settings for its
identification. The remote LED annunciator shall be
Cerberus Pyrotronics model LED-1, LED-2.
Operation
Upon actuation of a zone, the corresponding red LED will
light. Each additional actuated zone will light its corre-
sponding LED. The Remote Annunciator can be tested
using the Lamp Test feature of the Control Panel to indicate
proper functioning of the LEDs.
Programming
Remote LED annunciators are field programmable. Field
programming for the LED Series Remote Annunciator must
be performed when a new unit is installed. Annunciators
are programmed by placing the Control Panel in the
programming mode and the next available address will be
assigned to the annunciator when it has the programming
tool applied to it.
Installation
LED Series Remote Annunciators must be installed in
easily accessible locations. The unit(s) can be semi-flush
wall mounted using a single gang electrical box. Multiple
Description
Cerberus Pyrotronics Remote LED Annunciator units are
designed to be used with the IXL Control Panel. It is an
eight-point annunciator containing sixteen LED’s for the
display of trouble and alarm status or initiating devices.
LED Series Remote Annunciators can be located in the
building lobby or in a protected area. In its quiescent
mode of operation, all LED’s are off. In the event of an
alarm, a red LED will light to indicate which device or zone
is in alarm. To report troubles (i.e., removal of a detector
head), the corresponding yellow LED will light, indicating
which devices have been programmed as a single zone,
then only one LED will light regardless of the number of
devices in that zone indicating the trouble condition. The
Remote Annunciator may be tested by using the Lamp
Test feature of the Control Panel.
Annunciators perform the important service of pinpointing
the location of the alarm device or the zone from which an
alarm originates.
Engineer and Architect Specifications
Remote LED annunciators will have LED’s for Alarm and
Trouble per point. There will be eight points per annuncia-
tor, and it shall be connected to the IXL Network Communi-
9356
CATALOG NUMBER
firealarmresources.com