Owner's Manual

AnaLASER
TM
Air Sampling Detection
ENGINEER AND ARCHITECT SPECIFICATIONS
Introduction
The AnaLASER
TM
Control Card, Model ACC, is used in
AnaLASER
TM
control units and in conjunction with
AnaLASER
TM
air sampling detectors. The ACC displays
smoke intensity, measured by the detector, in an illumi-
nated bar graph display. One ACC is used for each
detector.
Smoke intensity, alarm conditions, and system troubles
can be communicated to fire alarm control panels via on
board dry contact relays. These same conditions are
stored in the ACC’s own history buffer. Finally, they can
also be output to a chart recorder or other recording
device.
Description/Operation
The ACC, housed in the control unit, is connected to the
AnaLASER
TM
detector via a six wire cable. Analog signals
for smoke and air flow are transmitted along this cable to
the ACC. Power to operate the detector and fan is also
carried on this cable.
The ACC provides all the visual and mechanical interaction
required to operate its respective detection zone. All
detection zone inputs, outputs and data ports are obtained
from plug in connectors located on the front of the card.
Each detection zone operates as a stand alone system.
The ACC is a microprocessor based device with several
programmable parameters. All programmable parameters
are factory set to default values. In most applications no
programming is required to make the system operational.
ACC AnaLASER
TM
Control Cards
l Bargraph Display of Smoke Intensity
l Microprocessor Controlled
l Real-time Monitoring via PC
l Three Field Programmable Alarm
Levels
l Alarm Verification at all Levels
l Detector Calibration Test
l Detector Isolate Switch
l Air Flow and Detector Status
Indicators
l On-board History Storage
l Listed, FM Approved
1162
CATALOG NUMBER
firealarmresources.com