User manual

5.2 Eth
The Eth object provides access to Ethernet network
The Eth object corresponds to the Interface MIB2 described in RFC
5.2.1 Eth Commands
Note:
The Eth object is always followed by one or more name strings that
correspond to por
In the commands below, this string is represented as
For more details on this convention, see
Objects.
5.2.1.1 Set
Assign and modify device parameters using the Set command:
set eth <eth-list>
[admin up | down]
[alias <string>]
[eth-
type <eth
[auto-
neg {enabled | disabled}]
[loopback
[lo
opback
[alarm-
propagation {disabled | backward | forward | both directions}
5.2.1.2 Show
Display device parameters using the Show command:
show eth [{<eth-
list> | all}
[{info | description | mtu | mac
| last-
change | name | alias | eth
| auto-
neg | loopback
| alarm
-
The Eth object provides access to Ethernet network
-
related device parameters.
The Eth object corresponds to the Interface MIB2 described in RFC
-2863.
The Eth object is always followed by one or more name strings that
correspond to por
ts or devices to be acted upon.
In the commands below, this string is represented as
<eth-
list>
For more details on this convention, see
Section 4.9.6.,
Designating Named
Assign and modify device parameters using the Set command:
[admin up | down]
[alias <string>]
type <eth
-type-set>]
neg {enabled | disabled}]
[loopback
-mode { disabled | external | internal}]
opback
-timeout <integer>]
propagation {disabled | backward | forward | both directions}
Display device parameters using the Show command:
list> | all}
[{info | description | mtu | mac
-
addr | admin | operational
change | name | alias | eth
-type | eth-act-
type
neg | loopback
-mode | loopback-
timeout | statistics
-
propagation}]]
Page 99
related device parameters.
The Eth object is always followed by one or more name strings that
list>
.
Designating Named
propagation {disabled | backward | forward | both directions}
addr | admin | operational
type
timeout | statistics
4Gon www.4Gon.co.uk [e-mail] Tel: [phone] Fax: [phone]