User manual

4.9.4.2
Show Commands
The Show command is used to display the current characteristics and other values for a
chosen object.
The generic form the Show command is:
show object
If a show
command is entered in an incomplete f
automatically complete missing object
with the keyword info.
For example:
When this Command is entered…
show system
show eth
show bridge-port
show bridge-port c2
show bridge-
port c2 eth0
show vlan
show vlan s1
show vlan s1 123-170
For more information on the
Reference source not found.
Note: The
auto completion
attributes which are required for correct command interpretation.
For example,
because it lacks a required reference to the object
When a show
command is entered with the
the reference to the non-
existing object is silently ignored. However, the information
requested for all existing objects will be displayed.
Display Formats
Both line-by-
line and table methods are available fo
depends upon the object being displayed.
Show Commands
The Show command is used to display the current characteristics and other values for a
The generic form the Show command is:
show object
-name <object-ids> [attribute-name]
command is entered in an incomplete f
orm, when possible, the CLI will
automatically complete missing object
-ids with the keyword all
, and missing attributes
When this Command is entered…
…the CLI interprets
the Command as:
port c2 eth0
show system info.
show eth all info.
show bridge-port all all info
show bridge-port c2 all info
show bridge-port c2 eth0 info
show vlan all all info
show vlan s1 all info
show vlan s1 123-170 info
For more information on the
FibeAir 70 CLI auto completion feature, see
Section
Reference source not found.
.
auto completion
mechanism does not enable the om
ission of object
attributes which are required for correct command interpretation.
For example,
show vlan 123-170 will not be correctly
auto completed
because it lacks a required reference to the object
s1.
command is entered with the
names or ids of an object that does not exist,
existing object is silently ignored. However, the information
requested for all existing objects will be displayed.
line and table methods are available fo
r displaying attributes. The method used
depends upon the object being displayed.
Page 82
The Show command is used to display the current characteristics and other values for a
orm, when possible, the CLI will
, and missing attributes
the Command as:
Section
Error!
ission of object
-ids or
attributes which are required for correct command interpretation.
auto completed
names or ids of an object that does not exist,
existing object is silently ignored. However, the information
r displaying attributes. The method used
4Gon www.4Gon.co.uk [e-mail] Tel: [phone] Fax: [phone]