User manual

Page 77
This chapter describes how to use the FibeAir 70 Command Line Interface (CLI) client to
configure and maintain FibeAir 70 devices on your network.
Topics covered here include:
• Invoking the CLI
• CLI command syntax
• Referring to FibeAir 70 objects
• Managing FibeAir 70 objects
• Displaying FibeAir 70 objects
• CLI help and auto completion
• CLI error messages
Hint:
This chapter provides information and procedures on basic FibeAir 70 CLI
operations. For more advanced operations, see Chapter 6.
4.8 Invoking the CLI
Run your standard Telnet/SSH client. A secured conne
ction is recommended. You
can use a common, open source SSH client programs such as PuTTY.
Enter the ODU’s default IP address: 192.168.0.1 / 24 and open the connection.
Login as user admin.
Enter the password admin.
At the SSH client prompt, enter cli.
When a successful connection is established, the ODU responds as follows:
Ceragon-OS
FA-70>
FibeAir 70 CLI commands should be entered only at the above prompt.
4Gon www.4Gon.co.uk [e-mail] Tel: [phone] Fax: [phone]