User manual

Page 63
Examining VLAN Statistics
In the event of VLAN performance problems, ODU transmission can be monitored using the
show vlan statistics command:
FA-70>show vlan all all statistics
component vlan port in-pkts out-pkts drop-pkts elapsed-time
c1 1 host 0 0 0 0000:00:00:32
c1 100 host 96 0 0 0000:00:00:32
c2 1 eth0 0 0 0 0000:00:00:32
c2 100 eth0 100 127 0 0000:00:00:32
c2 110 eth0 0 28601 0 0000:00:00:32
c2 120 eth0 0 28601 0 0000:00:00:32
c2 130 eth0 0 57180 0 0000:00:00:32
c3 1 eth1 0 0 0 0000:00:00:32
c3 110 eth1 28601 0 0 0000:00:00:32
c3 120 eth1 28601 0 0 0000:00:00:32
c3 130 eth1 71518 0 0 0000:00:00:32
c4 1 eth2 0 0 0 0000:00:00:32
c4 100 eth2 224 196 0 0000:00:00:32
4.5.2 Creating a Basic VLAN Configuration (Provider Bridge Disabled)
The previous configuration can also be implemented using the basic configuration available
when the Provider Bridge Feature is disabled.
This basic VLAN configuration example is for FibeAir 70 sites serving a single customer or
service provider. It comprises:
• Two paired FibeAir 70 RF units using local and remote in-band management
VLAN (VID 100) over port ETH0
• Three customer Ethernet VLANs (VIDs110, 120 and 130) using ports ETH1 and
ETH2
• Two network Hosts
• Management data from port ETH0 is sent to Host untagged
Configuring In-Band Management
Connect port ETH2 to Host and ETH0 using VID=100 (ETH2 and Host - untagged
on port):
set vlan 100 egress eth2,host,eth0 untagged eth2,host
Assign VID=100 to port ETH2 and Host (with Priority=7):
set bridge-port host pvid 100 prio 7
set bridge-port eth2 pvid 100 prio 7
Allow customer's VLANs on the link. Connect port ETH1 and ETH0 (RF) via S1
using customer’s VIDs:
set vlan 110,120,130 egress eth1,eth0 untagged none
4Gon www.4Gon.co.uk [e-mail] Tel: [phone] Fax: [phone]