User manual

Page 48
To check the IP settings:
3.3.4 RF
Set ODU’s RF parameters:
• F
requency [MHz]
• Channel-width [MHz]
• Role – Master or Slave
In a link one side should be configured as Master and the second as Slave.
• Transmit Asymmetry
For symmetric configuration (50% for Tx and Rx) use 50tx-50rx.
You may set the link to asymmetric configuration (75%/25%). In such case, set
75tx-25rx for the Master unit and 25tx-75rx for the Slave unit.
• Mode
The ODU supports 3 operation modes: Alignment (Carrier Wave transmission for
antenna alignment), Adaptive (adaptive bandwidth, code & modulation) and
Static (fixed modulation profile. Should be set to one of the available
modulation profiles supported).
After antenna alignment, set the ODU to adaptive to bring the link up.
Local_Site>show ip
ip 1 ip-addr : 192.168.0.11
ip 1 mask : 255.255.255.0
ip 1 route : 0.0.0.0
ip 1 destination : 0.0.0.0
ip 1 dst-mask : 255.255.255.0
ip 1 default-ipgw : 192.168.0.254
ip 1 vlan : 0
ip 4 ip-addr : 172.16.100.1
ip 4 mask : 255.255.255.0
ip 1 route : 0.0.0.0
ip 1 destination : 0.0.0.0
ip 1 dst-mask : 255.255.255.0
ip 1 default-ipgw : 0.0.0.0
ip 1 vlan : 4094
Local_Site>set rf frequency 72000
Local_Site>set rf role slave
Local_Site>set rf mode adaptive
4Gon www.4Gon.co.uk [e-mail] Tel: [phone] Fax: [phone]