User manual

Page 224
6.16 Outgoing Queues
6.16.1 Outgoing Queues Commands
6.16.1.1 Show
Display the Queue statistics using Show command:
show out-queue {{eth0, eth1, eth2, rf} | all} {1..8 | all} statistics
In response the software displays counters of all queues. The output is displayed in the table
as follows:
FA-70> show out-queue eth1 all statistics
interface qid tx drop elapsed-time
eth1 1 1321 3 0001:02:15:09
eth1 2 1543 1 0001:02:15:09
eth1 3 1435 0 0001:02:15:09
eth1 4 2345 0 0001:02:15:09
eth1 5 4563 0 0001:02:15:09
eth1 6 4563 0 0001:02:15:09
eth1 7 6547 9 0001:02:15:09
eth1 8 1256 0 0001:02:15:09
Note that for rf there are only four queues, thus only the number from 1 to 4 (or all) is
valid for the second ID. If all is specified then only four queuses are displayed.
6.16.1.2 Clear
Clear the Queue statistics using the Clear command:
clear out-queue {{eth0, eth1, eth2, rf} | all} {1..8 | all} statistics
Note that for rf there are only four queues, thus only the number from 1 to 4 (or all) is valid
for the second ID.
4Gon www.4Gon.co.uk [e-mail] Tel: [phone] Fax: [phone]