User manual

Page 152
Dependencies None
5.14.2.5 Mode Selector
Description Specifies the current RF device operating mode.
The available modes are: adaptive, static or alignment.
CLI Attribute Name mode
SNMP Object ID rfModeSelector (1.3.6.1.4.1.31926.2.1.1.6)
Value adaptive, static, alignment
When static mode is specified, the following sub-parameters are used
to define additional relevant operating characteristics:
Argument Description Values SNMP Reference
modu Modulation QPSK,
QAM16,
QAM64
rfModulationType
(1.3.6.1.4.1.31926.2.1.1.7)
num-subch Number of
subchannels
1..4 rfNumOfSubchannels
(1.3.6.1.4.1.31926.2.1.1.8)
repete Repetitions 1, 2, 4 rfNumOfRepetitions
(1.3.6.1.4.1.31926.2.1.1.9)
fec FEC rate 0.5, 0.67,
0.8
rfFecRate
(1.3.6.1.4.1.31926.2.1.1.10)
Access RW
Default Adaptive
Dependencies
When static mode is specified, only certain sub-parameter
combinations will produce a valid result. When an invalid combination is
specified on the command line, the CLI will respond with: ‘the modulation
does not exist in the modulation table’.
5.14.2.6 CINR Low
Description The lowest acceptable value for CINR, expressed in decibels (dB).
CLI Attribute Name cinr-low
SNMP Object ID rfCinrLow (1.3.6.1.4.1.31926.2.1.1.13)
Value -128..127
Access RW
Default 0
Dependencies None
4Gon www.4Gon.co.uk [e-mail] Tel: [phone] Fax: [phone]