User manual

Page 118
When the Provider Bridge feature is enabled, use the following syntax:
clear vlan {<comp-id-list> | all} {<vid-list> | all}
[statistics]
When the Provider Bridge feature is disabled, use the following syntax:
clear vlan {<vid-list> | all}
[statistics]
• Before deleting a C-VLAN, verify that it is not being used as a key to the C-
VLAN Registration Table. Do not delete the C-VLAN if such an entry exists.
• Before deleting an S-VLAN, verify that:
− the S-VLAN is not being used as the key in the PEP Virtual Port Table
(See Section 5.8) and S-VID Translation Table (See Section 5.9);
− the S-VLAN is not being used as Relay S-VID in the S-VID Translation
Table (See Section 5.9);
− the S-VLAN is not defined in any entry of the C-VLAN Registration
Table.
5.6.1.3 Show
Display VLANs using the Show command.
When the Provider Bridge feature is enabled, use the following syntax:
show vlan [{all | <component-id>}
[{all | <vids>}
[{info | statistics | fdb-id | egress | untagged}]]]]
When the Provider Bridge feature is enabled, use the following syntax:
show vlan
[{all | <vids>}
[{info | statistics | fdb-id | egress | untagged}]]]]
4Gon www.4Gon.co.uk [e-mail] Tel: [phone] Fax: [phone]