User manual

5.6 VLAN Table
The VLAN Table object enables the management of VLANs by the CLI. VLAN definitions are
stored in
a table containing static configuration information for each VLAN that is
configured into the device by local or network management.
All VLAN Table entries are permanent and will be restored when the device is reset.
This object corresponds to SNMP object
5.6.1
VLAN Table Commands
Note:
The use of
<comp
depending on whether the
disabled.
5.6.1.1 Set
Create and modify VLANs using
When the Provider Bridge feature is
set vlan <comp-id-
list> <vid
[fdb-
id <fdb
[egress <bridge
[untagged <bridge
When the Provider Bridge feature is
set vlan <vid-
list>
[<comp-
id
[fdb-
id <fdb
[egress <bridge
[untagged <bridge
5.6.1.2 Clear
Delete VLANs and clear their associated statistics using the Clear command.
The VLAN Table object enables the management of VLANs by the CLI. VLAN definitions are
a table containing static configuration information for each VLAN that is
configured into the device by local or network management.
All VLAN Table entries are permanent and will be restored when the device is reset.
This object corresponds to SNMP object
qBridgeVlanStaticGroup dot1qVlanStaticTable.
VLAN Table Commands
<comp
-id-list>
in VLAN Table CLI commands changes,
depending on whether the
FibeAir 70
Provider Bridge feature is enabled or
Create and modify VLANs using
the Set command.
When the Provider Bridge feature is
enabled, use the following syntax:
list> <vid
-list>
id <fdb
-id>]
[egress <bridge
-port-list>]
[untagged <bridge
-port-list>]
When the Provider Bridge feature is
disabled, use the following syntax:
list>
id
-list>]
id <fdb
-id>]
[egress <bridge
-port-list>]
[untagged <bridge
-port-list>]
Delete VLANs and clear their associated statistics using the Clear command.
Page 117
The VLAN Table object enables the management of VLANs by the CLI. VLAN definitions are
a table containing static configuration information for each VLAN that is
All VLAN Table entries are permanent and will be restored when the device is reset.
qBridgeVlanStaticGroup dot1qVlanStaticTable.
in VLAN Table CLI commands changes,
Provider Bridge feature is enabled or
4Gon www.4Gon.co.uk [e-mail] Tel: [phone] Fax: [phone]