User manual

Page 106
5.2.2.15 Loopback Timeout
Description Loopback timeout, expressed in seconds
CLI Attribute Name loopback-timeout
SNMP Object ID N/A
Value Integer
Access RW
Default Disabled
Dependencies None
5.2.2.16 Alarm Propagation Mode
Description Alarm propagation mode is used to define System behavior in case of a
link failure
CLI Attribute Name alarm-propagation
SNMP Object ID N/A
Value The possible alarm propagation values are:
Disabled No propagation is performed.
Backward The Ethernet link is set to down if the radio link is down or if
a “Peer Eth Down” notification has been received at the radio
interface.
Forward A “Peer Eth Down” notification is sent to the other end of the
radio link if the Ethernet link is down.
Both
Directions
Both Backward and Forward alarm propagation is performed.
Access RW (ETH1 and ETH2 only)
Default Disabled
Dependencies None
5.2.2.17 Statistics
The current CLI version displays all Eth object statistics together in response to the following
command:
show eth <ext-bridge-port-list> statistics
Table 5-1 summarizes and describes all Eth object statistics:
4Gon www.4Gon.co.uk [e-mail] Tel: [phone] Fax: [phone]