User manual

Page 104
5.2.2.11 Ethernet Type
Description This object identifier represents the operational type of MAU that the
administrator has assigned.
As described below, the use of this attribute is limited when auto-
negotiation is enabled for the MAU.
CLI Attribute Name eth-type
SNMP Object ID ifMauDefaultType (1.3.6.1.2.1.26.2.1.1.11)
Part of ifMauTable (1.3.6.1.2.1.26.2.1)
Value The possible values are:
10hd dot3MauType10BaseTHD (1.3.6.1.2.1.26.4.10)
10fd dot3MauType10BaseTFD (1.3.6.1.2.1.26.4.11)
100hd dot3MauType100BaseTXHD (1.3.6.1.2.1.26.4.15)
100fd dot3MauType100BaseTXFD (1.3.6.1.2.1.26.4.16)
1000hd dot3MauType1000BaseTHD (1.3.6.1.2.1.26.4.29)
1000fd dot3MauType1000BaseTFD (1.3.6.1.2.1.26.4.30)
1000sxhd dot3MauType1000BaseXHD (1.3.6.1.2.1.26.4.21)
1000sxfd dot3MauType1000BaseXFD (1.3.6.1.2.1.26.4.22)
1000lxhd dot3MauType1000BaseXHD (1.3.6.1.2.1.26.4.21)
1000lxfd dot3MauType1000BaseXFD (1.3.6.1.2.1.26.4.22)
Access RW
Default 1000fd
Dependencies If auto-negotiation is not enabled or is not implemented for this MAU, the
value of this attribute is used to determine the operational type of the
MAU. In such a case, a set command is used to force the MAU into the
specified operating mode.
If auto-negotiation is implemented and enabled for this MAU, the
operational type of the MAU is determined by auto-negotiation, and the
value of this attribute denotes the type to which the MAU will
automatically revert if/when auto-negotiation is later disabled.
5.2.2.12 Actual Ethernet Type
Description This object identifier represents the operational type of the MAU, as
determined by either:
1. the result of the auto-negotiation process, or
2. if auto-negotiation is not enabled or is not implemented for
this MAU, then the value that has been assigned in the eth-
type attribute is used (See Section 0).
CLI Attribute Name eth-act-type
SNMP Object ID ifMauType (1.3.6.1.2.1.26.2.1.1.3)
Part of ifMauTable (1.3.6.1.2.1.26.2.1)
Value The possible values are:
4Gon www.4Gon.co.uk [e-mail] Tel: [phone] Fax: [phone]