User manual

Page 102
Default N/A
Dependencies
If the Administrative Status attribute (admin) is in the Down state, then
the operational attribute should also be in the Down state.
If the Administrative Status attribute (admin) changes to the Up state,
then the operational attribute should also change to the Up state if the
interface is ready to transmit and receive network traffic. it should remain
in the Down state if and only if there is a fault condition that prevents the
interface from going to the Up state.
5.2.2.6 Last Change Time
Description The value of sysUpTime at the time the interface entered its current
operational state.
CLI Attribute Name lastChange
SNMP Object ID ifLastChange (1.3.6.1.2.1.2.2.1.9)
Value ddd:hh:mm:ss
Where:
ddd
= decimal integer representing days (it can be an arbitrary number
of digits)
hh
= two-digit decimal integer representing the hours of a day [0..23]
mm
= two-digit decimal integer representing minutes of an hour [0..59]
ss
= two-digit decimal integer representing seconds of a minute [0..59]
Access RO
Default N/A
Dependencies If the current operational state was entered prior to the last reinitialization
of the local network management subsystem, then the value of this
attribute is 0.
5.2.2.7 Name
Description The text string name of the interface.
CLI Attribute Name name
SNMP Object ID ifName (1.3.6.1.2.1.31.1.1.1.1)
Value host, eth0, eth1, eth2
Access RO
Default None
Dependencies None
4Gon www.4Gon.co.uk [e-mail] Tel: [phone] Fax: [phone]