Specifications

FibeAir 4800 Installation and Operation Guide Chapter 4 Configuration
FibeAir 4800 Installation and Operation Guide 4-25
4.12 Changing Community Values
The ODU communicates with the management application using SNMPv1
protocol. The protocol defines three types of communities:
• Read-Only for retrieving information from the ODU
• Read-Write to configure and control the ODU
• Trap used by the ODU to issue traps.
The community string must be entered at login. The user must know the password
and the correct community string in order to gain access to the system. A user may
have read-only privileges.
It is not possible to manage the ODU if the read-write or the read community
values are forgotten. A new community value may be obtained from technical
support for the purpose of setting new community; the serial number or the MAC
address of the ODU must be supplied.
The manager application and the ODU use the community strings public-bru1 for
the local unit and public-bru4097 for the remote unit. These are the factory
defaults, but can only be used one time on the first installation.
A new community string must be set when entering the system for the first time.
The read-write community and read-only community have a minimum of five
alphanumeric characters. (Bru1 and bru4097 are not permitted). Changing the
trap community is optional by clicking the check box.
Editing Community Strings
The community change dialog box is available from the Configuration > Security
tab. Both read-write and read-only communities must be defined.
On entering for the first time, use netman as the current community. The
community string must be changed when entering the system for the first time, and
the community string netman cannot be used again.
Note