Specifications

FibeAir 4800 Installation and Operation Guide Chapter 4 Configuration
FibeAir 4800 Installation and Operation Guide 4-13
4.5 Setting the T1 Line Code
The T1 line code can be set as B8Zs or AMI in the TDM Parameters dialog box.
The default is B8ZS.
®
To change the line code
1. Run the Configuration wizard until you reach the Services dialog box.
2. Verify that T1 services have been selected.
3. Click Next to open the TDM Parameters dialog box.
4. Set the line code to B8ZS or AMI as required.
5. Click Next to finish the wizard.
This dialog box is available only when TDM service was selected in the previous
Services dialog box.
1. Click Next.
The Finish screen appears, showing a summary of the link configuration
(see Figure 4-9).
Note