Specifications

Quick Start FibeAir 4800 Installation and Operation Guide
4 FibeAir 4800 Installation and Operation Guide
Signal quality increased
No change in signal
Signal quality decreased
[approx. 2s] No air link
Three beeps and a pause is the best signal
Two beeps and a pause, signal quality increased
One beep and pause is no signal change
Any other signal detects no signal between ODUs.
8. Secure the site B ODU to the mast/wall.
9. At site A, adjust the ODU slowly while listening to the beeper sequence until
the best signal is attained.
10. Secure the site A ODU to the mast/wall.
11. Monitor the link quality for about 15 minutes to verify stability.
12. Connect the management station to one of the two IDUs in the link.
13. Double-click the FA4800 Manager icon to start the application.
14. Click the Installation button to open the installation wizard and follow the
installation steps.
15. After selection of the radio channel and the link rate (as determined in the Link
Budget Calculator utility), verify that the link quality bar in the FA4800
manager is within the green range for TDM service and within the yellow
range for Ethernet service.
Achieve the best possible link quality values. In case of radio link loss, verify the
ODU alignment, or change the radio channel in both sides of the link. When the
radio link resumes, continue the installation process.
Note
Note