Specifications

FibeAir 4800 Installation and Operation Guide Chapter 4 Configuration
FibeAir 4800 Installation and Operation Guide 4-7
service. The adaptive modulation enables the user to maximize Ethernet
throughput without degradation of the TDM service quality.
When Ethernet only service is used, the adaptive modulation enables
improving the Ethernet performance in case of air performance
degradation (periodical interference or RSS changes).
Note that in case of interference at one site, there is no need to use a
lower modulation at the other site (as in previous versions). In such a case
the actual rate changes automatically only at the problematic site, while the
second side of the link maintains the highest rate possible (Asymmetric).
Adaptive modulation can be changed in both Installation and
Configuration wizards.
3. Type in the distance between the sites.
If TDM services are selected, then the Evaluate icon shows on the screen
whilst the maximum rate is evaluated.
When evaluation is complete the icon changes and the following message
is shown:
Service has been evaluated, click Next to continue.
4. Click Next.
The TDM Parameters dialog box or the Finish screen appears depending
on which services were selected.