Specifications

Chapter 4 Configuration FibeAir 4800 Installation and Operation Guide
4-4 FibeAir 4800 Installation and Operation Guide
FA4800 with Automatic Channel Select
Automatic Channel Select enables FA4800 to change frequency channels
automatically if interference is detected on the current operating channel.
Figure 4-3. Channel Select dialog box - Automatic Channel Select
®
To define automatic channel selection:
1. Select the main frequency from the Operating Channel menu.
2. Select the required Bandwidth 5, 10, or 20 MHz.
F2.x GHz versions operate at 10 or 20 MHz steps only.
3. Click the check box if Automatic Channel Selection is required.
4. Click the check boxes in the Available Channels List of all the allowable
channels that can be automatically selected.
5. If you are not satisfied with the channel that is selected automatically, click
Reselect Channel.
A new channel will be selected from one of the Available Channels that
have been defined.
By clicking Reselect Channel, the ODU starts scanning all the channels from the
available channels list and looks for radio frequency activity in each of the channels.
Note
Note