Specifications

FibeAir 4800 Installation and Operation Guide 4-1
Chapter 4
Configuration
This chapter describes configuration procedures, which are performed after the
physical installation of the local and remote FA4800 units and the Installation Link
wizard has been performed. A second wizard is used to redefine the configuration
parameters if necessary. Both sites in the link are defined simultaneously.
The following parameters are configured via the configuration wizard:
• System parameters
• Frequency channel
• Air interface rate
• Service parameters.
The following parameters are configured via the Configuration dialog box.
• Transmit power
• Management and trap addresses
• Bridge mode
• Ethernet mode
• Community values.
4.1 Configuring the System Parameters
After installing the link, the system configuration can be modified.
All parameter changes are automatically applied to both sides of the link.
®
To change general parameters:
1. In the Main menu, click the Link Configuration button.
2. The Configuration wizard opens (Figure 4-1).
Note