Specifications

FibeAir 4800 Installation and Operation Guide Chapter 2 Installation and Setup
FibeAir 4800 Installation and Operation Guide 2-25
2.15 Connecting the User Equipment
The IDU is a standalone desktop, wall-mounted or rack-installed unit. Figure 2-2
illustrates a typical rear panel of the IDU.
®
To connect user equipment to the IDU:
1. Connect user E1/T1 traffic to the IDU panel RJ-45 port designated TRUNK.
There may be multiple Trunk ports available depending on unit ordered.
Refer to Appendix A for the connector pinout.
2. Connect user hub/router or any other compatible device to the IDU panel
RJ-45 port designated LAN. There may be multiple LAN ports available for
connecting to different LANs depending on the IDU unit ordered.
Refer to Appendix A for the connector pinout.
•
Use a straight cable for router connection.
Do not connect two LAN ports to the same LAN, or flooding may occur.
Notes