Specifications

FibeAir 4800 Installation and Operation Guide Chapter 2 Installation and Setup
FibeAir 4800 Installation and Operation Guide 2-23
Figure 2-14. TDM Parameters dialog box
•
This dialog box is available only with IDU-E units, it is activated after TDM service
was chosen in the previous Service dialog box. In Ethernet only services, the TDM
dialog box does not appear.
Setting the T1 Line Code
The T1 line code can be set as B8Zs or AMI in the TDM Parameters dialog box.
The default is B8ZS.
®
To change the line code
1. In the TDM Parameters dialog box, set the line code to B8ZS or AMI as
required.
2. Click Next to show the finish screen.
Note