Specifications

Chapter 2 Installation and Setup FibeAir 4800 Installation and Operation Guide
2-20 FibeAir 4800 Installation and Operation Guide
Figure 2-13. Installation Wizard, Services dialog box
®
To select the services:
1. In the Service dialog box, select one of the following:
 E1/T1 – E1/T1 data and Ethernet data.
The Ethernet BW field shows the remaining bandwidth in Mbps available
for Ethernet. The available bandwidth depends on the number of E1/T1
ports selected.
 Ethernet Only
2. Select the required transmission rate.
If Adaptive is selected FA4800 constantly monitors and adjusts the transmission
rate to ensure maximum throughput for the link at the highest quality. ACCESS
versions are preset to adaptive and the rate selection is disabled.
3. Click Next.
If TDM services were selected, then the TDM parameters dialog box
appears, (see Figure 2-15).
4. The optimum transmission rate for the selected services is evaluated. Table 2-1
shows the rates used by FA4800. ACCESS versions do not have TDM services,
they operate at a rate of 2 Mbps.