Specifications

FibeAir 4800 Installation and Operation Guide Chapter 2 Installation and Setup
FibeAir 4800 Installation and Operation Guide 2-7
2.8 Installing FA4800 Management Software
The FA4800 management application is distributed on CD-ROM as an executable
file. The application has the following PC requirements:
• Memory: 128 MB RAM
• Disk: 1 GB free hard disk space
• Processor: Pentium 3 or higher
• Network: 10/100BaseT NIC
• Graphics: Card and monitor that support 1024×768 screen resolution
with 16 bit color
• Operating system: Windows 2000/XP
• Microsoft Explorer 5.01 or later.
®
To install the FA4800 management program:
1. Insert the CD-ROM into your CD-ROM drive.
2. The autorun feature starts to install the software automatically.
If the installation does not start automatically, run setup.exe.
3. Follow the on-screen instructions of the installation wizard to complete setup
of the FA4800 Management program in the desired location.
Any PC running the FA4800 management application can be used to configure
FA4800 units.
2.9 Connecting the Power
•
Before connecting any cable, the protective earth terminals of the AC/DC
adapter must be connected to the protective ground conductor of the mains
power cord. If you are using an extension cord (power cable) make sure it is
grounded as well.
Any interruption of the protective (grounding) conductor (inside or outside the
instrument) or disconnecting of the protective earth terminal can make this
unit dangerous. Intentional interruption is prohibited.
Connecting Power to an IDU-E
Power is supplied to the FA4800 IDU-E via an external AC/DC converter, which
receives power from a 100–240 VAC source and converts it to -48 VDC.
®
To connect power to the IDUs:
1. At site A, connect the 2-pin connector of the AC/DC converter to the 2-pin DC
power connector on the IDU rear panel.
2. Connect the AC/DC converter 3-prong plug to a mains outlet.
Warning