User's Manual Chapter 3

FibeAir 1500 Installation & Operation Manual Chapter 3. Installation
Revision 2.0 Flow of Operations 3-5
3.7. Flow of Operations
The installation and setup procedure for the FibeAir 1500 consists of the
following operations (to be performed in the order listed below):
GiganetView Management Software:
■ Installing the Management Software
■ Installing a PPP/SLIP Driver
■ Setting the Baud Rate
IDU:
■ Installing the IDU
■ Turning IDU On
■ Connecting to a PPP/SLIP or Ethernet Port
■ Setting the IP addresses
■ Setting Local Tx Frequency Channel
■ Activating Engineering Order Wire (EOW)
■ Setting Antenna Diameter and Distance
■ Determining the Expected Signal Level
ODU:
■ Installing the antenna assembly
— Azimuth adjustment
— Elevation adjustment
■ Initial antenna alignment − using a compass, Giganet’s optical view
finder and headset.
■ Alignment − checking actual receive level
■ Performing an Initial Check
■ Verifying Installation.