User's Manual Chapter 3

Chapter 3. Installation FibeAir 1500 Installation & Operation Manual

3-22 Installation Instructions Revision 2.0

attach ODU to

mount usin

4 latch

(L)

Figure 3-20 Antenna Assembly (cont.)

9. Connect the coaxial cable between the IDU and ODU using the

N-Type connector on the IDU and the ODU.

10. Make sure that the fittings and the coax cable are clean and dry.

11. Peel approximately 6 inches of COAX-SEAL from the paper backing.

12. Wrap isolation tape over the coax cover. Start winding from coax cover

towards fitting with one half overlap with each winding making sure all

joints are well covered.

Figure 3-21 Steps 1, 2 & 3

13. After entire fitting and coax cable are covered with approximately 3/16"

thick layers, mold and form COAX-SEAL with fingers to make a smooth

surface and force out any air.

Rubber O-ring