User's Manual Chapter 3

FibeAir 1500 Installation & Operation Manual Chapter 3. Installation

Revision 2.0 Installation Instructions 3-19

3. Place the assembly constructed above ((C) and (D)) and U bolt (E)

around the pole on the safety assembly (attached in Step 1) and

connect the two. Before doing this, make sure that the elevation spindle

(F) is in hole (G) and loosen the screws on both sides to grant freedom

of movement.

place around pole

above safety collar (B)

and tighten

slip (F) into hole (G)

loosen nuts

around (F)

(C)

(D)

(F)

(E)

(G)

Figure 3-15 Antenna Assembly (cont.)

Following step 3 the assembly should be as illustrated in the follwing figure.

Figure 3-16 Antenna Assembly (cont.)

4. Attach the antenna (H) to the antenna mount (I).

Step 1

Step