User's Manual Chapter 3

FibeAir 1500 Installation & Operation Manual Chapter 3. Installation
Revision 2.0 Installation Instructions 3-17
1. Place U bolt (A) and safety collar (B) around the pole at the desired
height, connect them and tighten in place at a 90° angle to the opposing
site direction.
Place around pole
desired height
a
n
d
t
i
g
h
t
e
n
(A)
(B)
Safety collar
Ubolt
Figure 3-13 Antenna Assembly (cont.)
Note
The safety collar assembly shown in Figure 3-14 above ((A) and (B)) is used to align
and support the antenna mount during installation and antenna alignment. Once the
mount is in place and alignment is completed, all bolted joints of the antenna mount are
tightened and there is no further need for the support provided by the safety collar
assembly. It may then be removed for use in future installations.