User's Manual Chapter 3

Chapter 3. Installation FibeAir 1500 Installation & Operation Manual
3-14 Installation Instructions Revision 2.0
Note
Since there is no connection with the remote terminal, you can change only Local Unit
parameters at this stage.
2. In the top of the window, select the diameter of the Local Antenna from
the drop-down list (1, 2, 3, 4, or 6 foot). The default value is 1 foot.
3. In the top center of the window, select the distance using the
buttons.
4. In the top right of the window, select the diameter of the Remote
Antenna from the Antenna drop-down list (1, 2, 4, or 6 ft.).
5. In the Transmitter section, set Tx Level of the Local Unit to the maximum
allowed Tx level to facilitate the alignment process.
Note that the Transmit Level should be adjusted following antenna
alignment (see Chapter 4 for details).
6. In the Transmitter section, set Tx Level of the Remote Antenna to the
maximum setting to facilitate the alignment process.
7. Click Apply.
8. Make a note of the expected signal level displayed in the Unfaded RL
field.
For example, in the window shown above the expected value is
-35
dBm for the remote side and – 26dBm for the local receiver.
9. Click Cancel.
The ODU Configuration window is closed and you are returned to the
Work Area window.
3.9.12. Exiting GiganetView Management Software
1. In the Work Area window, select File ½ Exit to exit the Management
software.
The Work Area and Physical Area and Physical View windows are
closed.
2. Turn off the IDU.
The following sections describe the installation procedures for 1 foot and 2
foot antennas which are the most frequently used. For procedures on
installing other antennas, see the Antenna Information appendix.