User's Manual Chapter 3

Chapter 3. Installation FibeAir 1500 Installation & Operation Manual
3-12 Installation Instructions Revision 2.0
3.9.10. Setting Local Tx Frequency Channel
If the Tx frequency was previously defined using the Hyperterminal, use this
screen only to verify that the correct frequency was set.
1. Select Configuration ½ Set frequency.
The Frequency Plan window is displayed.
Figure 3-9 Frequency Plan Window
At the top of the window, the system displays Tx/Rx ranges, the gap
between them according to the appropriate standard (FCC or ETSI) and the
channel bandwidth.
2. In the Frequency Control section, set the Tx Channel to the required
channel. By default it is set to the first channel. If you are unsure of the
required channel, refer to Appendix E for FCC or ETSI channel
allocations.
The frequency of the selected Tx channel appears in the Tx Frequency
field.
3. If you prefer, you may set the Tx frequency by entering a frequency in
MHz In the Tx Frequency section. If a channel is available for this
frequency, it will appear in the Set Tx Channel field. If not, a warning
message appears to enable the entered frequency or to change it to the
next available channel.
4. Select the Local Only option (radio button should be filled ♦).
By default, the Local + Remote option is selected.
However, since there is no connection to the remote unit at this time, the
Local + Remote option is not available.