Installation Instructions Chapter 4

Chapter 4. System Setup FibeAir 1500 Installation & Operation Manual
Revision 2.0 The Setup Procedure 4-9
4.2.7. Setting the IP Addresses
To set the IP Addresses, perform the following operations:
1. Connect to the Terminal.
2. From the Main Configuration menu, select Full Configuration.
3. From the Full Configuration menu, select (1) IP Configuration. The IP
Configuration menu appears.
Figure 4-7 FibeAir 1500 Terminal - IP Configuration Menu
For Ethernet Configuration:
6. Select (1) Agent\Ethernet IP Address, and enter the IP address.
7. Select (2) Agent\Ethernet IP Mask, and enter the IP mask.
For Serial Communication (Slip, PPP, or Dial-up Modem):
8. Select (3) Serial Address, and enter the serial address.
9. Select (4) Serial Mask, and enter the serial mask.
10. Select (5) Default Gateway Router, and enter the router’s address.
11. Select (S) Save & Return to save the settings and return to the Full
Configuration menu.
12. Restart the IDU.