Installation Instructions Chapter 4

Chapter 4. System Setup FibeAir 1500 Installation & Operation Manual
Revision 2.0 The Setup Procedure 4-5
The PPP protocol adds security to the communication and therefore
additional parameters need to be configured in the system:
— Authentication Protocol Type:
0 – None
1 – PAP (without encryption)
2 – CHAP (with encryption)
— Authentication Mode:
2 – GUEST. The IDU gives the user name and password to the
network manager.
3 – HOST. The IDU receives the user and password from the
network manager and validates them.
4 – DYNAMIC. When the IDU receives a phone call, it acts as a
HOST. If it initiates a call to the network manger (SNMP trap) it will
act like a GUEST. In case of a direct connection (without a dialup
modem) it acts as a HOST.
— Dial-In Authentication User Name: Enter the user name that is
used to validate a user dialing in to the indoor unit.
— Dial-In Authentication Password: Enter the password that is used
to validate a user dialing in to the indoor unit.
— Dial-Out Authentication User Name: Enter the user name that will
be used by the IDU to gain access to the remote manager.
— Dial-Out Authentication User Password: Enter the Password that
will be used by the IDU to gain access to the remote manager.
— Transmit Frequency: The frequency Channel number you wish to
use.
— Transmit Power: Power output level.